340 mm shock absorbers for bed, pack of 2 units.

Replacement shock absorbers for articulated frames of lifting bed system.

Our shock absorbers are manufactured in Europe and therefore offer a high level of quality and durability. They are shock absorbers that you can trust, where the force exerted corresponds to that indicated on the shock absorber body so that you can be sure that you are applying shock absorbers with the correct force and thus, do not cause damage to your platform and hardware due to inappropriate pressure. and sometimes excessive that does not correspond to the indication!

Easy application or replacement. Compatible with practically all models of lifting brackets without clip-on springs.

The fitting at both ends is made through eyelet-type holes and fixed with two anti-loosening nuts. You should check if it is compatible with your articulation system.

Various pressure powers available.

The shock absorbers exert very strong pressure and, therefore, it is not possible to close them by hand without them being mounted on the corresponding hardware applied to the bed. If this happens, it means that the shock absorbers are damaged and need to be replaced.

It's a simple process, just loosen the screws at each end of the shock absorber, replace the shock absorber and tighten the nut again.

The nuts must be anti-loosening, so it is neither necessary nor convenient for the shock absorber to be too tight, it should leave a slight gap so that it can move when raising and lowering the mattress.

Sold in a pack of 2 units.

We recommend replacing the two shock absorbers, therefore, we sell the shock absorbers in a pack of 2 units to maintain the same pressure on both sides and thus prevent the bed from warping.

Care to take into account

You must not close/lower the bed base without having placed the mattress. The shock absorbers exert a very strong and localized pressure, exerting too much force can bend and/or break the deck. You should only do this with the mattress in place, the mattress distributes the weight evenly across the base, helping to distribute the pressure!

Shock pressure guide table:

Comments!

1. These indications refer to the total weight of the mattress with clothes and are merely indicative
2. In case of exchange for reasons not attributable to J. CARDOSO Móveis, the shipping / return costs are at the customer's expense.

HEADS UP! All dampers are under pressure. For security reasons should not disassemble the shock absorbers, injury hazard!