Shock absorber to bed 340 mm

Shock absorber for system articulated squares for lifting beds.

Easy application or replacement. Compatible with virtually all models of lifting brackets.

The fitting at both ends is made through eyelet holes and fixed with two nuts. You should check that it is compatible with your joint system.

Various pressure powers available.

Sold by the unit.

We sell the shock absorbers to the unit, however, we always recommend replacing the 2 units, so that you keep the pressure equal on both sides to avoid warping the platform.

Care to take into account

You should not close / lower the bed frame without placing the mattress. The dampers exert very strong and localized pressure, if you try too hard, you can bend and / or break the pallet. You should only do this with the mattress on, the mattress distributes the weight evenly across the platform, helping to distribute the pressure!

Shock pressure guide table:

900N - For single mattresses

1000N - For lighter double mattresses up to 140 cm

1150N - For double mattresses springs up to 150 cm

1250N - For mattresses of double springs up to 160 cm.

1300N - For double mattresses springs up to 160 cm

1400N - For heavier double mattresses over 160 cm

1500N - For mattresses over 180 cm

1600N - For mattresses 200 cm

1800N - For extra heavy mattresses 200 cm

Comments!

1. These indications refer to the width of the mattress and are merely indicative and may vary depending on the measurements and / or weight of the mattress.
2. In case of exchange for reasons not attributable to J. CARDOSO Móveis, the shipping / return costs are at the customer's expense.

HEADS UP! All dampers are under pressure. For security reasons should not disassemble the shock absorbers, injury hazard!